Sections 2. This repair does not require the use of a soldering iron but......
Arturo Wilson Member since: Removing the battery connector cover. Exterior screw cover. Outer cover. Add Comment.
Bill Detwiler has nothing to disclose. Small - 600px Medium - 800px Large - 1200px.
Use a T4 screwdriver for this one screw. Step 5 Let the Fix Begin!
Internal hardware. Single Step Full Guide. Tools Featured in this Teardown Buy these tools.
I did not complete this guide. Atmel MXT224E touchscreen controller. Time Required 5 - 10 minutes. I cracked open the first Droid Razr and wanted to see what the new model had inside. Battery frame.
Add Comment. Tilt the Droid Maxx towards your right so you can see the edge of the rubber back case and keep this position. We Are All Geniuses. Vibration motor. I found the big connector to the screen wasn't in all the way.
At first it didn't work and had to open it up again.Droid RAZR MAXX Repair - Back Cover Removal
Note that there is a total of eight 11 black screws spread across the motherboard, four 4 at the top and four 4 at the bottom, and also two 2 silver screws located to the right lower part of the Droid Maxx. Step 3 Removing the Back Cover.
Maintain the same position all times unless indicated otherwise in subsequent steps. Removing the battery. Do not go along the bottom to remove the case.